Getting Started with BPI-R4

Development

Basic Development

Prepare to develop

 * Prepare 8G/above TF card, USB-Serial cable, Ubuntu System
 * Using your USB-Serial cable Connect to debug console on BPI-R4
   G=Groung;  RX=BPI-R4 input;  TX=BPI-R4 output
    

 * BPI-R4 bootstrap and device select Jumper Setting
    

  * Examples:

 1. All Jumper is "1", BPI-R4 will boot from SD card
    

 2. SW3-A is "0" and SW3-B is "1" , BPI-R4 will boot from SPI NAND
    

 3. SW3-A is "1" and SW3-B is "0" , BPI-R4 will boot from eMMC
    

 4. If the console said "system halt!", it means that the bootup storage does not cotain any OS

Error creating thumbnail: Unable to save thumbnail to destination

Accessories

1. 10G SFP Module

The SFP serdes of BPI-R4 requesting link mode inband/10gbase-kr, so only SFP that support this protocol can be used！

Usually the PIN6 of 10G SFP+ module is GND. After inserting the module, SFP_MOD_DEF0 will be pulled low, thereby turning on the SFP power supply.

Therefore, if this PIN of the module is not GND, 3.3V_SFP power will not be supplied!

10G SFP+ Copper Module

The temperature of this module is very high when used for a long time, It can reach 90℃ without a heat sink or cooling fan. Be careful to prevent burns!

Note:

Do not pull out this module once it is inserted, otherwise it will cause BPI-R4 to reboot.This phenomenon does not exist with other modules.

10G SFP+ Fibre Module